Designed solely for military use, the buck and ball cartridge has been around from as early as the Revolutionary War.  During the War of 1812, it was the standard issue military round.  The cartridge usually contained a .69 caliber round shot with three additional round buckshot, these being approximately .31 caliber.  The cartridges were fabricated alternatively with the round ball against the powder, or held forward of the buckshot.  In addition, approximately 110 grains of black powder was neatly packaged within the brown paper wrap.  The larger shot was intended to strike the primary target, with the buckshot scattering and causing additional injury in the opposing lines.  This ammunition was used with significant impact when fired at close range from a smoothbore musket.  But at distances beyond 150 yards, accuracy declined and the smaller buckshot quickly lost energy.

 During the Civil War, these cartridges were manufactured by the millions at seventeen Federal arsenals and numerous additional state facilities.  At Watervliet Arsenal in West Troy, New York, nearly 2½ million buck and ball cartridges were fabricated in 1862 alone.  Specimens of .69 caliber round shot and .31 caliber buckshot are found on virtually every Civil War battlefield.

 This cartridge is wrapped in brown paper and tied with red string.  The ball end is fastened closed with a tie, the tail is folded closed.  Its overall length is 2½”.   Within this example, the buckshot surmounts the ball.  Although assembled both ways, a study conducted at Watervliet Arsenal in 1848 indicated that accuracy for both the round ball and the buckshot was increased when the ball was placed against the powder and used as a gas seal to push the buckshot down the barrel upon discharge.

The Shaler three piece conical bullet is one of the most interesting bullets to see service in the Civil War.  It is a multi-piece .58 caliber bullet that was invented by Reuben Shaler of New York.  After discharge, the three sections were intended to spread apart allowing for more impact points on a designated target, but with far greater accuracy than its buck ‘n ball counterpart.  The nose section was to follow the line of fire of a standard mini-ball, while the two base portions with less than perfect shape after emerging from the barrel would diverge slightly and broaden the target impact area. As the war progressed, Shaler’s bullet design evolved as he endeavored to improve its accuracy and range. 

Shaler began to market his sectional bullet to the War Department only a few months after the firing on Fort Sumter.  His sales effort was to last through the duration of the war and resulted in only lackluster interest from the Federal army.